Re: Stiff GAV

Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Posted by Tom Endy on Mar. 12, 2010 at 11:49:59

In Reply to: Stiff GAV
posted by Steve Longden on Mar. 12, 2010 at 10:05:32

I just bought several GAV drivers from one of the better suppliers to find they were all corroded inside the tunnel and each would bind up. I was able to correct the problem by bead blasting the corrosion out. I called the supplier and he was going to investigate. If it is the valve stem itself remove the clip at the bottom and spread the fingers. You can spread the clip and put it back on, or leave it off. If the threads themselves are tight all you can do is discard it and try another. Tom Endy

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

Follow Ups: Remove ring Brian Burkert Mar. 17, 2010 at 15:24:30 (0) A few years ago I bought a repro Tom Wesenberg Mar. 12, 2010 at 18:45:23 (1) Re: A few years ago I bought a repro Tom Endy Mar. 13, 2010 at 01:01:53 (0)

Post a Follow Up Message:

Your Name:      (Required)

Your E-Mail Address:      (Required)

Remember your Name and E-mail Address?

Subject of your Comment:       (Required)

Enter Your Message Below:      (Required)

Web Site Link URL    (Your homepage maybe!!!)
(must end in "/" or ".htm" or ".html" or ".shtml")

The above Links Title:

If you have a picture place image URL here:
(must end in ".gif" or ".jpg" with no spaces)

Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam