Re: Set timing with electronic ignition

Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Posted by John Wing on Jul. 09, 2009 at 18:57:21

In Reply to: Re: Set timing with electronic ignition
posted by Bill L on Jun. 30, 2009 at 09:44:21

This is how I do it but it is not easy setting the rotor. Mechanicaly Time the engine with pin. Now the hard part is to postion rotor at "0" (TDC) on the Nu-Rex scale with the lever full up retarded at #1 plug. I have set it, start the motor read the scale with timing light and do over a couply times before it's right. J Wing

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

Follow Ups:

Post a Follow Up Message:

Your Name:      (Required)

Your E-Mail Address:      (Required)

Remember your Name and E-mail Address?

Subject of your Comment:       (Required)

Enter Your Message Below:      (Required)

Web Site Link URL    (Your homepage maybe!!!)
(must end in "/" or ".htm" or ".html" or ".shtml")

The above Links Title:

If you have a picture place image URL here:
(must end in ".gif" or ".jpg" with no spaces)

Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam