"flywheel knocker"


Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Posted by Gary Stewart on Jul. 02, 2009 at 22:25:01

In Reply to: Re: On Snyder's web site...
posted by Jim on Jul. 02, 2009 at 19:40:41

I have several different sizes that I use to remove flywheels from small gas engines. You thread it all the way on, then back off 1/4 turn. The "knocker" prevents thread damage. You can use a regular nut, flush with the end of the shaft, but it isn't as safe.


Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

Follow Ups:



Post a Follow Up Message:

Your Name:      (Required)

Your E-Mail Address:      (Required)

Remember your Name and E-mail Address?

Subject of your Comment:       (Required)

Enter Your Message Below:      (Required)

Web Site Link URL    (Your homepage maybe!!!)
(must end in "/" or ".htm" or ".html" or ".shtml")

The above Links Title:

If you have a picture place image URL here:
(must end in ".gif" or ".jpg" with no spaces)




Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam