On Snyder's web site...

Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Posted by Dave Goodman on Jul. 02, 2009 at 14:28:38

In Reply to: Fan removal tool
posted by Leo S on Jul. 02, 2009 at 14:05:18

it says, "To remove the fan, thread this special nut on the end of the pump shaft. By holding the fan and giving this tool a few good hits with the hammer, it will brake the fan blade loose from the shaft. USA" (Spelling is theirs.) Makes no sense to me, either.

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

Follow Ups: Re: On Snyder's web site... Jack Dernorsek Jul. 02, 2009 at 18:09:30 (7) Re: On Snyder's web site... keith true Jul. 07, 2009 at 17:42:32 (0) Don't hold the blade, just grab the hub Tom Wesenberg, Mn. Jul. 03, 2009 at 13:09:24 (0) Re: On Snyder's web site... Jim Jul. 02, 2009 at 19:40:41 (4) Re: On Snyder's web site... Leo S Jul. 07, 2009 at 07:49:28 (1) Re: On Snyder's web site... RayinLaMesa Jul. 07, 2009 at 09:36:02 (0) "flywheel knocker" Gary Stewart Jul. 02, 2009 at 22:25:01 (1) Re: "flywheel knocker" Tim Stephens Jul. 02, 2009 at 23:25:33 (0)

Post a Follow Up Message:

Your Name:      (Required)

Your E-Mail Address:      (Required)

Remember your Name and E-mail Address?

Subject of your Comment:       (Required)

Enter Your Message Below:      (Required)

Web Site Link URL    (Your homepage maybe!!!)
(must end in "/" or ".htm" or ".html" or ".shtml")

The above Links Title:

If you have a picture place image URL here:
(must end in ".gif" or ".jpg" with no spaces)

Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2010, Ahooga.Com

Anti Spam