You MAY be able to...

Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Posted by Axeman on May 15, 2008 at 17:50:47

In Reply to: Re: bent rear axle shaft threads
posted by ED on May 15, 2008 at 13:09:16

...you MAY be able to put a nut or two on to protect the threads, then apply heat and pressure to straighten it out. The worry I would have would be that if you apply too much heat you may weaken the metal and that is NOT a good place to have weak metal

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

Follow Ups:

Post a Follow Up Message:

Your Name:      (Required)

Your E-Mail Address:      (Required)

Remember your Name and E-mail Address?

Subject of your Comment:       (Required)

Enter Your Message Below:      (Required)

Web Site Link URL    (Your homepage maybe!!!)
(must end in "/" or ".htm" or ".html" or ".shtml")

The above Links Title:

If you have a picture place image URL here:
(must end in ".gif" or ".jpg" with no spaces)

Read Follow Ups Post Follow Up Model-A Ford Message Board FAQ

Previous PageE-Mail Comment to WebmasterPost New MessagePrint MessageClose Window

© 1996-2007, Ahooga.Com

Anti Spam